Matrix Setu ATA211G Spezifikationen PDF herunterladen (Seite 95)

Matrix SETU ATA211G System Manual 89

If a perfect match is found, SETU ATA211G will start sending the IP packets to the corresponding Gateway

Address configured in the table.

If no match is found, SETU ATA211G will send the IP Packets to the default Gateway Address you configured in the

“Network Parameters” page.

Configuring Static Routing Table

The Static Routing Table must be configured at each location where SETU ATA211G is installed.

1. Log in as Admin.

2. Click the Advanced Settings link to expand.

3. Click Static Routing.

The Static Routing Table opens.

The Static Routing Table allows you to configure up to 5 entries. Each entry is stored against an Index

number.

For each entry, you must configure the following fields:

• Destination Address: This is the address of the final destination where the call is to be made. This

can be a device IP Address or Network Address.

• Subnet Mask: This is the mask to be applied on destination address.

• Gateway Address: This is the IP address of the node where the IP packets are to be sent. Generally,

it is the IP address of the LAN interface of the Router (to which SETU ATA211G is connected).

The Gateway Address must be in the same subnet as SETU ATA211G.

4. Click Submit to save your entries.

1 2 ... 90 91 92 93 94 95 96 97 98 99 100 ... 183 184

Keine Kommentare

Matrix Setu ATA211G Spezifikationen Seite 95