Matrix Setu ATA211G Spezifikationen PDF herunterladen (Seite 43)

Matrix SETU ATA211G System Manual 37

• In the On Time field, set the time for which the DTMF digit should remain on, when the digit is dialed

out by the system. The DTMF On Time may be 100 or 150 or 200 milliseconds. Default: 100

milliseconds.

• In the Off Time field, set the time for which system should wait before dialing the successive DTMF

digits. The DTMF Off Time may be 100 or 150 or 200 milliseconds. Default: 100 milliseconds.

10. Configure the Pause Timer (sec), if you want to insert a delay before the digits of a number string is out

dialed from the SIP trunk.

The Pause Timer is typically used in “Multi Stage Dialing”. The range of the Pause Timer is from 1 to 9

seconds. Default: 2 seconds.

11. Select an appropriate Call Hold Method that is compatible with your ITSP proxy server/remote peer.You

may select:

• RFC 3261

• RFC 2543

Default: RFC 3261

12. To send and receive the Fax over IP from and on the FAX machine connected to FXS port of the SETU

ATA211G, select the desired Fax over IP protocol:

• T.38 (UDPTL): If you select this option, the device you are sending the fax to, must also support this

protocol.

• Pass Through: Select this option if you need to send fax over G.711. The device you are sending fax

to must also use G.711.

Default: T.38 (UDPTL).

If the FAX sent using T.38 is rejected, SETU ATA211G will use Pass Through as the Fall Back protocol to

send the fax.

13. In the Returned Calls to Original Caller (RCOC) option, enable the type of RCOC you want to set for the

SIP Trunk. See “Return Call to Original Caller (RCOC)”

• On Busy: Enable this type if you want to set RCOC when the call is returned if the called party is found

busy.

• On No Response: Enable this type if you want to set RCOC when the call is returned if the called party

does not answer the call.

• On Speech: Enable this type if you want to set RCOC when the call is returned after speech was

established with the called party.

14. If you have completed the configuration of SIP Trunk 1, click Submit to save settings.

15. To configure another SIP trunk, click the SIP Trunk Number tab.

16. Follow the same instructions as described here to configure the next SIP trunk.

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 183 184

Keine Kommentare

Matrix Setu ATA211G Spezifikationen Seite 43